I'm not really keen on the idea of using a fixed full rpm router or at best a few set points of rpms for a spindle. So I was intending to use a spindle and power supply for my build. I've found a few spindles rated from 300w-600w and 48v-110v that would seem to be capable of light aluminum work.
What have you guys seen as a good spec point for aluminum work?
Much past the 300w mark though most switching power supplies just don't provide enough voltage. What do you guys use for power...
Spindle/power supply selection?
What have you guys seen as a good spec point for aluminum work?
Much past the 300w mark though most switching power supplies just don't provide enough voltage. What do you guys use for power...
Spindle/power supply selection?