Have upgraded TinyG firmware but still unable to run a series of jobs without re-setting board, re-homing and re-G92ing. If I run a Vectric cut2d file (like below) twice, without rebooting board, on second run z axis moves up until trips limit switch. Any suggestions?
G90
G17
G20
G64
G0Z0.5010
G0X0.0000Y0.0000
M3 S18000
G0X5.1247Y3.1676Z0.5000
G1Z-0.0625F10.0
G1X5.1399Y3.1467F20.0
X5.1512Y3.1394
————-
Etc.
————-
G2X4.9541Y1.6791I0.2011J0.1703
G2X4.9218Y1.7697I0.4751J0.2203
G1X4.9123Y1.8096...
constant re-homeing between each job?
G90
G17
G20
G64
G0Z0.5010
G0X0.0000Y0.0000
M3 S18000
G0X5.1247Y3.1676Z0.5000
G1Z-0.0625F10.0
G1X5.1399Y3.1467F20.0
X5.1512Y3.1394
————-
Etc.
————-
G2X4.9541Y1.6791I0.2011J0.1703
G2X4.9218Y1.7697I0.4751J0.2203
G1X4.9123Y1.8096...
constant re-homeing between each job?