Hi Guys:
This question has probably been asked a hundred times before, but what is the recommended control system for something like the C-Beam Machine or the OX?
I plan on using 2,8A NEMA 23 motors, and the fact that the y axis has 2 motors on it has me leaning toward a 4 axis setup, or 3 axis with 2 motor drivers wired in parallel. But, what software? GRBL, or Mach 3?
What do I need for the system? I assume some sort of BOB, a processor running g-code interpreter, and an...
What controller?
This question has probably been asked a hundred times before, but what is the recommended control system for something like the C-Beam Machine or the OX?
I plan on using 2,8A NEMA 23 motors, and the fact that the y axis has 2 motors on it has me leaning toward a 4 axis setup, or 3 axis with 2 motor drivers wired in parallel. But, what software? GRBL, or Mach 3?
What do I need for the system? I assume some sort of BOB, a processor running g-code interpreter, and an...
What controller?