Hi..I did a bit if a search but didn't find anything about this other than the standard way of joining V-Slot lengths using the double T- nuts, etc. The problem I see is the alignment needs to be extremely accurate, which I believe would be problematic without more precise locating elements.
If we had pins the diameter of the round holes in the extrusions..I believe those could be used as locating pins and then the double T-nuts would only be needed to provide the strength of the join...
Joining Lengths of V-Slot 40mm x 40mm (or others)
If we had pins the diameter of the round holes in the extrusions..I believe those could be used as locating pins and then the double T-nuts would only be needed to provide the strength of the join...
Joining Lengths of V-Slot 40mm x 40mm (or others)