Hi all.
I'm a graphic designer/sheep farmer/bluegrass musician in Florida and am just getting into CNC. I have been reading up on it for quite awhile but this is my first project. The 5 -axis controller is built, tested and ready. I basically just have to finish the Y axis, mount the drag chains, run the wires and load the software. I plan to try it with Mach3 to begin with, then later upgrade to something else if needed.
All of this is made from 8020 15 series except the trusses in the center...
Foam Cutter......need double sided V-rail
I'm a graphic designer/sheep farmer/bluegrass musician in Florida and am just getting into CNC. I have been reading up on it for quite awhile but this is my first project. The 5 -axis controller is built, tested and ready. I basically just have to finish the Y axis, mount the drag chains, run the wires and load the software. I plan to try it with Mach3 to begin with, then later upgrade to something else if needed.
All of this is made from 8020 15 series except the trusses in the center...
Foam Cutter......need double sided V-rail