Hello world!;
I came across this great forum while I was trying to mod a G5 Powermac computer case and found out that hand cut parts are not sleek and accurate enough.
So I have been spending a lot of time reading, inspecting parts and designs and try to create a BOM for my CN build.
I came up with a design that is a mix of c-beam and OX and of course other fellow builders already been there.
I have 3 main concerns for my design (please note that I am a total newbie with openbuilds parts...
My First Design & Questions
I came across this great forum while I was trying to mod a G5 Powermac computer case and found out that hand cut parts are not sleek and accurate enough.
So I have been spending a lot of time reading, inspecting parts and designs and try to create a BOM for my CN build.
I came up with a design that is a mix of c-beam and OX and of course other fellow builders already been there.
I have 3 main concerns for my design (please note that I am a total newbie with openbuilds parts...
My First Design & Questions