Hi All,
I'm finally up to the point where I'm about to hop into the parts store and start purchasing parts. I basically made two sets of drawings...trying to decide which road to take as far as using V-slot or Open Rail. So...what style does everyone feel is the most accurate of the two. I'm not leaning either way at this point. Any and all suggestions would be very appreciated. I have a good metal shop setup, so if that has any bearing on which way to go. Look forward to everyone's...
V-Slot vs. Open Rail style CNC Mill/Router...?
I'm finally up to the point where I'm about to hop into the parts store and start purchasing parts. I basically made two sets of drawings...trying to decide which road to take as far as using V-slot or Open Rail. So...what style does everyone feel is the most accurate of the two. I'm not leaning either way at this point. Any and all suggestions would be very appreciated. I have a good metal shop setup, so if that has any bearing on which way to go. Look forward to everyone's...
V-Slot vs. Open Rail style CNC Mill/Router...?