I've been searching the threads for some info and I'm having trouble finding some good info to start with.
I'm trying to figure out what microstep setting to use. I can go down to 1/32 step, should I?
This is the controller I have. Arduino CNC Shield – 100% GRBL Compatable | Protoneer.co.nz
Should all three axis use the same microstepping?
Is it possible to flip the Y axis C-Beam so the motor is in the front? This will help...
Initial setup questions for C-Beam Machine
I'm trying to figure out what microstep setting to use. I can go down to 1/32 step, should I?
This is the controller I have. Arduino CNC Shield – 100% GRBL Compatable | Protoneer.co.nz
Should all three axis use the same microstepping?
Is it possible to flip the Y axis C-Beam so the motor is in the front? This will help...
Initial setup questions for C-Beam Machine