I finally got a little time to work on my CNC machine.
I'm trying to get the Grbl configuration settings entered, and I'm struggling.
I found a site on the internet ( http://noblesque.org.uk/ShapeOko/grblcalc/ ) and was trying to work through the calculations. At this point, I have removed all step jumpers on my CNC Xpro controller board. Here is some specific information about my machine: It's modeled after the Open Builds OX design with an overhead gantry. I'll be running a...
I need some help...
I'm trying to get the Grbl configuration settings entered, and I'm struggling.
I found a site on the internet ( http://noblesque.org.uk/ShapeOko/grblcalc/ ) and was trying to work through the calculations. At this point, I have removed all step jumpers on my CNC Xpro controller board. Here is some specific information about my machine: It's modeled after the Open Builds OX design with an overhead gantry. I'll be running a...
I need some help...