So, I've had the default plates running for a few months now and I can see some areas of improvement. Just documenting my procedure in this thread for the community, if you want to make them too I can share the files.
I moved the X rails up 15mm and back 25mm, so the cutter is in line with the front of the plate when mounted. Also added a dip to easier access the grub screws in the belt pulleys. Added some slots for your belt to go out of for tension purposes. Center 2 wheels brought closer...
Re-Design of all Gantry/Joining plates.
I moved the X rails up 15mm and back 25mm, so the cutter is in line with the front of the plate when mounted. Also added a dip to easier access the grub screws in the belt pulleys. Added some slots for your belt to go out of for tension purposes. Center 2 wheels brought closer...
Re-Design of all Gantry/Joining plates.