So, when doing calibration i found it a real headache because after a move, the motors shut off and would revert to their last full step, which is a bout 1-2mm of movement in the gantry. Jog 100mm, it moves 101mm and snaps back to 99.4 and just causes a headache when trying to calibrate it all, until I discovered this setting today:
"$1 - Step idle delay, msec
Every time your steppers complete a motion and come to a stop, Grbl will delay disabling the steppers by this...
OpenStore Motor power settings?
"$1 - Step idle delay, msec
Every time your steppers complete a motion and come to a stop, Grbl will delay disabling the steppers by this...
OpenStore Motor power settings?