I just finished my OX CNC build, but having issues with motor current.
I am using the CNC xPro controller from openbuilds
Nema 23 motor from openbuilds.
bosch colt router
My build is 1000mm by 1000mm using the OX plates, gives me a 818mm by 700mm cutting area.
My issue is that i am not getting any cutting force to speak of. I have created a job in Sketchup to plane my spoiler board to level the board to my spindle. If i set my feed rate to around 800 then i can cut a depth around 1-2mm,...
Ox CNC motor issues
I am using the CNC xPro controller from openbuilds
Nema 23 motor from openbuilds.
bosch colt router
My build is 1000mm by 1000mm using the OX plates, gives me a 818mm by 700mm cutting area.
My issue is that i am not getting any cutting force to speak of. I have created a job in Sketchup to plane my spoiler board to level the board to my spindle. If i set my feed rate to around 800 then i can cut a depth around 1-2mm,...
Ox CNC motor issues