Hi,
I just recently assembled my 1000 x 1500 ox, and I've run into some frustration calibrating it.
Specs:
1000mm X, 1500mm Y
CNC Xpro controller with heatsinks and fan
24v Openbuilds power supply
BlueOx mounts/ plates
Single GT3 belts
Dewalt 611 router
1/8" 2 flute downcut endmill
Vectric Aspire
The machine will be used to cut/ route .093" ABS sheets, and wood.
I've adjusted the steps so that I can ask for 1000mm in the Y and it gives me 1000mm (no load).
Same with the X; I ask for 800mm...
Hardware issue? Where to start looking?
I just recently assembled my 1000 x 1500 ox, and I've run into some frustration calibrating it.
Specs:
1000mm X, 1500mm Y
CNC Xpro controller with heatsinks and fan
24v Openbuilds power supply
BlueOx mounts/ plates
Single GT3 belts
Dewalt 611 router
1/8" 2 flute downcut endmill
Vectric Aspire
The machine will be used to cut/ route .093" ABS sheets, and wood.
I've adjusted the steps so that I can ask for 1000mm in the Y and it gives me 1000mm (no load).
Same with the X; I ask for 800mm...
Hardware issue? Where to start looking?