Quantcast
Channel: OpenBuilds
Viewing all articles
Browse latest Browse all 6775

C-Beam Machine instructions

$
0
0
I have just finished building my C-Beam Machine. The quality of the parts and the finished machine are outstanding - thank you.

The instructional video is very good but I have one minor suggestion:

When I was getting near the end I found that I had run out of 8mm M5 bolts but had a surplus of 10mm M5 bolts. On investigation I realised that the 8mm bolts should only be used where the direction of the bracket follows the slots and the 10mm ones are for where the bracket is at right...

C-Beam Machine instructions

Viewing all articles
Browse latest Browse all 6775

Trending Articles