Hi
Here is my find about the control of any cnc, as mainly how to get rid of a pc.
The solution so far available are : Mach3 software, Linuxcnc software, Chillipr and grbl soft.
GRBL look to control only 3 stepper with 3 single controller. I would like 4 stepper, as 2 nema23 on the Y axis.
On the controller itself, all Gecko540, mx6600 and bobcad at 15$ are all related to parallel port. So you need a pc right across the cnc mostly all time.
I note for over 8 source, the TB5540 will...
Recap of controller and remote access
Here is my find about the control of any cnc, as mainly how to get rid of a pc.
The solution so far available are : Mach3 software, Linuxcnc software, Chillipr and grbl soft.
GRBL look to control only 3 stepper with 3 single controller. I would like 4 stepper, as 2 nema23 on the Y axis.
On the controller itself, all Gecko540, mx6600 and bobcad at 15$ are all related to parallel port. So you need a pc right across the cnc mostly all time.
I note for over 8 source, the TB5540 will...
Recap of controller and remote access