I have a C-Beam machine with Nema 23s and previously used a GRBLShield/Arduino combo but when it recently got fried I replaced it with an X-Pro board.
The board works fine but the motors are a lot noisier than they were with my previous setup.
The motor movement vibrates the whole chassis and makes it rattle. Movement is accurate with no mis-stepping so the wiring is correct and the board is functioning correctly. Movement used to be smooth as silk.
I have tried various micro-stepping...
Noisy X-Pro
The board works fine but the motors are a lot noisier than they were with my previous setup.
The motor movement vibrates the whole chassis and makes it rattle. Movement is accurate with no mis-stepping so the wiring is correct and the board is functioning correctly. Movement used to be smooth as silk.
I have tried various micro-stepping...
Noisy X-Pro