Hi guys,
Just built my new C-Beam machine, but the motors sound a little 'gritty' when running, along with a moderate vibration on the x and y axes.
Are there any areas I should focus on to eliminate/reduce these flaws?
Not sure if my bearings may be too tight or there's something I'm missing.
Thanks,
Will
Just built my new C-Beam machine, but the motors sound a little 'gritty' when running, along with a moderate vibration on the x and y axes.
Are there any areas I should focus on to eliminate/reduce these flaws?
Not sure if my bearings may be too tight or there's something I'm missing.
Thanks,
Will