I was assembling a system in Solidworks based on a 40x80mm C-Rail and ran into an issue where something is not lining up properly.
When I mate my wheels so they are tangent to the V portion of the rail, then the mounting holes for the wheel assemblies are not concentric with the wheel hubs.
In the attached picture, I show the distance between the mounting holes on the V-Slot gantry plate, and the distance between the centers of the corresponding locating features on the wheel assemblies....
Possible Error in Dimensions in Solidworks Parts Library?
When I mate my wheels so they are tangent to the V portion of the rail, then the mounting holes for the wheel assemblies are not concentric with the wheel hubs.
In the attached picture, I show the distance between the mounting holes on the V-Slot gantry plate, and the distance between the centers of the corresponding locating features on the wheel assemblies....
Possible Error in Dimensions in Solidworks Parts Library?