Hi,
I have access to an old CNC router that uses HY200 3424 stepper motors (NEMA 34); see link below to pdf. They are rated 4.7 A, 90 Volt and 150/193 Nm. I would like to run them with a CNC xPro, or similar. Could someone recommend me a possible replacement or what specifications that I need to look for?
HY200 3424 (pdf):
http://www.probyte.fi/pdf/HY200-3424-0170.pdf
Will the below stepper work if I can get the shaft to fit?...
Replacement for NEMA 34 steppers
I have access to an old CNC router that uses HY200 3424 stepper motors (NEMA 34); see link below to pdf. They are rated 4.7 A, 90 Volt and 150/193 Nm. I would like to run them with a CNC xPro, or similar. Could someone recommend me a possible replacement or what specifications that I need to look for?
HY200 3424 (pdf):
http://www.probyte.fi/pdf/HY200-3424-0170.pdf
Will the below stepper work if I can get the shaft to fit?...
Replacement for NEMA 34 steppers