Im running GRBL 0.9i on a scratch built machine
Im having a couple of problems because im using standard measurement as opposed to metric and the machine setup readout stays in metric.
Instead of writing a long novel im just going to bullet point my major problems.
-I have $N0=G20F7.8 but the machine forgets to set itself to standard when I boot up and that screws up my homing process. it's dropping G20 for some reason.
-The machine homes to the switches from where I start it but...
GRBL Controller Issues
Im having a couple of problems because im using standard measurement as opposed to metric and the machine setup readout stays in metric.
Instead of writing a long novel im just going to bullet point my major problems.
-I have $N0=G20F7.8 but the machine forgets to set itself to standard when I boot up and that screws up my homing process. it's dropping G20 for some reason.
-The machine homes to the switches from where I start it but...
GRBL Controller Issues