Can't figure out how to make the offset feature work. So I must not understand.
As example I have a pen tool so work height is the table top. This is my work flow:
1. I postion my C-Bean near the edge of the front left corner with the pen at the top of the table and I set this for zero XYZ then disconnect Grbl panel and reconnect to set all to zero. I then raise the z 1".
I've previously created a simple 1" square box with 0 thickness in scetchup and used phlatzboyz extension to create the...
Ggbl Panel Offsets. Trying to understand
As example I have a pen tool so work height is the table top. This is my work flow:
1. I postion my C-Bean near the edge of the front left corner with the pen at the top of the table and I set this for zero XYZ then disconnect Grbl panel and reconnect to set all to zero. I then raise the z 1".
I've previously created a simple 1" square box with 0 thickness in scetchup and used phlatzboyz extension to create the...
Ggbl Panel Offsets. Trying to understand