Hi everybody,
I bought CNC xPRO Controller V2 on August 2015. Since then, I made a CNC router. I use Universal G Code Sender to drive my motors. Many times during the last months, I drived my four motors Nema 23 with my board and the software without any problem.
I just noticed that my Z axis is not anymore sending current to my Z motor. To see if wiring was the problem, I disconnected the Z axis motor and plugged it on other axis board's terminals, and it worked. Also, I used a multimeter...
Z axis not working anymore - CNC xPro Controller V2
I bought CNC xPRO Controller V2 on August 2015. Since then, I made a CNC router. I use Universal G Code Sender to drive my motors. Many times during the last months, I drived my four motors Nema 23 with my board and the software without any problem.
I just noticed that my Z axis is not anymore sending current to my Z motor. To see if wiring was the problem, I disconnected the Z axis motor and plugged it on other axis board's terminals, and it worked. Also, I used a multimeter...
Z axis not working anymore - CNC xPro Controller V2