Everything was working well with my Ooznest Ox with CNC Xpro until i changed vacuums.
My Vacuum is not on all of the time the OX is cutting and i tend to put it on part way through cuts to remove debris. With my old Vac this was never an issue and i could do this whenever without issues.
Now, with my new vac (Bigger and 'better') whenever i use it part way through a cut, within a minute or so of using it the OX stops all movement. Universal G Code sender does not come up with an error...
Strange issues with OX since new shop vac installed - OX Stops Responding
My Vacuum is not on all of the time the OX is cutting and i tend to put it on part way through cuts to remove debris. With my old Vac this was never an issue and i could do this whenever without issues.
Now, with my new vac (Bigger and 'better') whenever i use it part way through a cut, within a minute or so of using it the OX stops all movement. Universal G Code sender does not come up with an error...
Strange issues with OX since new shop vac installed - OX Stops Responding