A little while back I purchased a Simplify3D licence for ver. 3.1
It seems there were some problems with the software creating junk code which would cause smoothie to freeze.
One apparent solution is a gcode cleaner but I wanted to see if version 3.1 can deliver without that, so last night I printed a tall tube, 30 mm diameter, 3 mm wall thickness, 150 mm tall, to also test any machine drift. All was printed from a non-cleaned gcode file, and the results are in the pics below....
Simplify3D and Smoothieboar. They seem to work
It seems there were some problems with the software creating junk code which would cause smoothie to freeze.
One apparent solution is a gcode cleaner but I wanted to see if version 3.1 can deliver without that, so last night I printed a tall tube, 30 mm diameter, 3 mm wall thickness, 150 mm tall, to also test any machine drift. All was printed from a non-cleaned gcode file, and the results are in the pics below....
Simplify3D and Smoothieboar. They seem to work