Hi All,
I've browsed this forum for a few hours, and I am still confused about where to start my journey. Firstly, let me outline my 'wishlist'.
I want to cut shapes out of aluminium sheet up to 1/4" (6mm) thick on a table bed of 48" x 24" (1200mm x 600mm)![:)]( "Smile :)")
I've read about the C-Beam Machine Mechanical Bundle and the OX machine
Where do I start?
Do I need the C-Beam to make parts for the OX machine?
Is...
Advice on getting started
I've browsed this forum for a few hours, and I am still confused about where to start my journey. Firstly, let me outline my 'wishlist'.
I want to cut shapes out of aluminium sheet up to 1/4" (6mm) thick on a table bed of 48" x 24" (1200mm x 600mm)
I've read about the C-Beam Machine Mechanical Bundle and the OX machine
Where do I start?
Do I need the C-Beam to make parts for the OX machine?
Is...
Advice on getting started