Hey.
So I had just finished wiring up my new xPro v2 board today. I was powering it from a current limited lab powersupply for the first couple of tests just to be on the safe side. I connected the v2 to my pc and changed a couple settings (steps/mm.etc) then fired up the power supply. I jogged the Z axis, worked as it should. Then move on to the X axis (there is where the trouble began!) After that the board become unresponsive ever since. When any power is supplied to the board it now...
CNC xPro V2 board completely dead! Seems faulty?
So I had just finished wiring up my new xPro v2 board today. I was powering it from a current limited lab powersupply for the first couple of tests just to be on the safe side. I connected the v2 to my pc and changed a couple settings (steps/mm.etc) then fired up the power supply. I jogged the Z axis, worked as it should. Then move on to the X axis (there is where the trouble began!) After that the board become unresponsive ever since. When any power is supplied to the board it now...
CNC xPro V2 board completely dead! Seems faulty?