Greetings all
I am frustrated with Mach3 and trying to configure the software I could use some help. Should I continue using Mach 3 or change. I bought a china controller with 3 nema 23 motors and 1 nema 17 motor. I am using the demo of mach3 with the mm unit settings and every time I try to run the roadrunner gcode it flies to the end of the table and just sits there with the motors going nut. I am waiting for the plates for the micro switches to install the homing stuff but at this point I...
CNC OX with Mach3
I am frustrated with Mach3 and trying to configure the software I could use some help. Should I continue using Mach 3 or change. I bought a china controller with 3 nema 23 motors and 1 nema 17 motor. I am using the demo of mach3 with the mm unit settings and every time I try to run the roadrunner gcode it flies to the end of the table and just sits there with the motors going nut. I am waiting for the plates for the micro switches to install the homing stuff but at this point I...
CNC OX with Mach3