Hey guys. I finally got all my kit together and wired it up. I have the CNC Shield V3 and Arduino Uno, a set of 3 NEMA 23's and 24V power supply. I did up a quick Sketch in Sketchucam and sent it off to the controller. It seemed to be working fine for about 1/2 of the project. (ran for may 20-30 seconds) Then the steppers stopped responding even though the project was still running in the UGS java applet. I checked the heatsinks on the DRV 8825 drivers and they were VERY hot. I...
CNC Shield V3
CNC Shield V3