Just spent the morning drawing up a case bottom for my Arduino Uno/CNC Shield in Sketchucam. Not sure how it happened but it ended up upside down! ![:confused:]( "Confused :confused:")
LOL!!
I flipped it over and sent it out to UGCS and it seemed to run.
Time to try again. Haven't had this much fun and 'grey matter' exercise in a long time...![:)]( "Smile :)")
Paul
LOL!!I flipped it over and sent it out to UGCS and it seemed to run.
Time to try again. Haven't had this much fun and 'grey matter' exercise in a long time...
Paul