Hi
I have a CNC xPro V2 board, that looks to be wired up properly and jogs the machine in all the right directions (when connected through Universal GCode Sender), however, I am trying to change some of the settings - specifically, the S100, S101 and S102 (X, Y and Z steps/mm). Basically, the axes move about 5mm for every 1mm I tell it to go - default settings ar at 200 and they need to be about 26.
I've never done this before, so was assuming that a command typed into the Command Line in...
CNC xPro V2 and Changing GRBL Settings
I have a CNC xPro V2 board, that looks to be wired up properly and jogs the machine in all the right directions (when connected through Universal GCode Sender), however, I am trying to change some of the settings - specifically, the S100, S101 and S102 (X, Y and Z steps/mm). Basically, the axes move about 5mm for every 1mm I tell it to go - default settings ar at 200 and they need to be about 26.
I've never done this before, so was assuming that a command typed into the Command Line in...
CNC xPro V2 and Changing GRBL Settings