Hi all,
My apologies if this has been asked before. A quick search didn't show anything.
I have a XPro CNC driver. I'm only wanting to use a single motor to build a translation table. I still want the ability to home the axis. But, from what I understand, the homing program looks for switch transitions on the Z-axis first, followed by the X and Y. And it's not just a simple case of permanently closing the X and Y limit switches.
I think the solution is to disable the homing requirement of...
Disable homing on X & Y axes only - XPRO
My apologies if this has been asked before. A quick search didn't show anything.
I have a XPro CNC driver. I'm only wanting to use a single motor to build a translation table. I still want the ability to home the axis. But, from what I understand, the homing program looks for switch transitions on the Z-axis first, followed by the X and Y. And it's not just a simple case of permanently closing the X and Y limit switches.
I think the solution is to disable the homing requirement of...
Disable homing on X & Y axes only - XPRO