Hello all,
I amnew to these forums and have been reading through to find info on the DQ542MA stepper driver. There are lots o hits when I search but I haven't found anything with basic connection and operation info.
I am looking at the DQ542MA to be used with the NEMA 23 Stepper Motor. The DQ542MA manaul does not have much info.
If I connect PUL-, DIR-, ENBL- to GND and PUL+, DIR+ to positove potentional will the stepper run forward at full speed when positive potentioal is put on to ENBL+...
DQ542MA stepper driver connections?
I amnew to these forums and have been reading through to find info on the DQ542MA stepper driver. There are lots o hits when I search but I haven't found anything with basic connection and operation info.
I am looking at the DQ542MA to be used with the NEMA 23 Stepper Motor. The DQ542MA manaul does not have much info.
If I connect PUL-, DIR-, ENBL- to GND and PUL+, DIR+ to positove potentional will the stepper run forward at full speed when positive potentioal is put on to ENBL+...
DQ542MA stepper driver connections?