I built an OX based router and I am driving it with a TinyG controller. I have it pretty much nailed down, but I am having a problem with homing the machine. I am using chillipeppr to drive it.
I have 6 switches, 3 are set to home/limit (1 per axis) and the other 3 are set to limit. All are wired to be NC
If I just manually put the machine in about the home position and run the chillipeppr demo gcode, it performs correctly (well, it moves in the right directions, I have not installed the...
TinyG home/limit problem.
I have 6 switches, 3 are set to home/limit (1 per axis) and the other 3 are set to limit. All are wired to be NC
If I just manually put the machine in about the home position and run the chillipeppr demo gcode, it performs correctly (well, it moves in the right directions, I have not installed the...
TinyG home/limit problem.