Hey all,
Total stepper newb so looking for some help here. Having trouble with my stepper motor project.
I'm using:
Wanta DQ542MA 2H Microstep driver
NEMA 17 stepper motor from open builds store
Arduino Uno
24V DC power supply
I have PUL+, DIR+, and ENBL+ wired to pins 5,6,7 on the arduino, and PUL-, DIR-, ENBL-, DC-, and Arduino's GND all wired together.
The DIP pins I have are set to 1 - OFF, 2- ON, 3 - ON, 4 - OFF, 5- OFF, 6 - OFF, 7 - ON, 8 - ON
This should give 1.46A Peak and...
NEMA 17 - DQ542MA - Arduino Stepper Setup
Total stepper newb so looking for some help here. Having trouble with my stepper motor project.
I'm using:
Wanta DQ542MA 2H Microstep driver
NEMA 17 stepper motor from open builds store
Arduino Uno
24V DC power supply
I have PUL+, DIR+, and ENBL+ wired to pins 5,6,7 on the arduino, and PUL-, DIR-, ENBL-, DC-, and Arduino's GND all wired together.
The DIP pins I have are set to 1 - OFF, 2- ON, 3 - ON, 4 - OFF, 5- OFF, 6 - OFF, 7 - ON, 8 - ON
This should give 1.46A Peak and...
NEMA 17 - DQ542MA - Arduino Stepper Setup