Quantcast
Channel: OpenBuilds
Viewing all articles
Browse latest Browse all 6775

seeking advice on set up for cutting wood cylinders

$
0
0
I am considering a lathe setup specifically related to cutting cylinders, like a banjo lathe. This would likely involve two X and two Y planes, similar to what is shown below. The exterior cuts are straightforward enough and could be accomplished with a variety of set ups. My primary concern is the interior cuts. Ideally the reach of this lathe would be in the range of 16 inches on the X axis. The first picture below shows a shallow cylinder, perhaps only 4 inches. I would like to cut...

seeking advice on set up for cutting wood cylinders

Viewing all articles
Browse latest Browse all 6775

Trending Articles