Hey, all. I've been continually tweaking and using my Ox derivative "Cebu" All has been working well, for the most part, especially since replacing the Z axis with C-Beam.
The problem is this - recently I tried to cut something that required a fairly close precision (cutting a row of .5" diameter holes .8475" deep in 1" thick padauk) and discovered that my machine was not tuned properly. Circles weren't round, and the diameter was too small by several hundredths of an inch.
So, I...
Stepper calibration questions
The problem is this - recently I tried to cut something that required a fairly close precision (cutting a row of .5" diameter holes .8475" deep in 1" thick padauk) and discovered that my machine was not tuned properly. Circles weren't round, and the diameter was too small by several hundredths of an inch.
So, I...
Stepper calibration questions