Hello everyone,
I need some help for my 3d printer, actually I making sailfish based 3d printer of size 500mm each having stable bed and vertically moving XY gantry.
I am done with the designing part and have somewhat completed my build and was testing the z axis with some combinations like--
1. Lifting the z axis with two motors placed at center ,as this will not require any timing belt, and supporting the gantry with four 10mm smooth rods at the corners(refer picture- With two motors)....
Building a large 3d printer of volume 500mmX500mmX500mm
I need some help for my 3d printer, actually I making sailfish based 3d printer of size 500mm each having stable bed and vertically moving XY gantry.
I am done with the designing part and have somewhat completed my build and was testing the z axis with some combinations like--
1. Lifting the z axis with two motors placed at center ,as this will not require any timing belt, and supporting the gantry with four 10mm smooth rods at the corners(refer picture- With two motors)....
Building a large 3d printer of volume 500mmX500mmX500mm