I have built a CNC ox and I have been trying to tune the motors with Mach 3 and a Gecko G540 since March of this year (2016).
I can get the motors to move the axis but x and y axis will stall, switch direction for no apparent reason. The Z axis will only go down but not up. I am running Xp 32-bit. I have tried the onboard parallel port and a new...
Need Help With Tuning Motors on CNCox with mach3 and Gecko G540
I can get the motors to move the axis but x and y axis will stall, switch direction for no apparent reason. The Z axis will only go down but not up. I am running Xp 32-bit. I have tried the onboard parallel port and a new...
Need Help With Tuning Motors on CNCox with mach3 and Gecko G540