Hi everyone,
I had some trouble trying to engrave my name on my new C-Beam, please see attached.
I don't yet understand G-Code and would appreciate any help rectifying the gouging that happened at the start of my code. I am using a V-bit at speed 6 on a makita. I used fusion 360 with GRBL post processing and I believe I have Grbl 0.9j (flashed on a Grbl AOI from 3dtek.xyz).
Any input is greatly appreciated.
Here's the code:
G-Code Help
I had some trouble trying to engrave my name on my new C-Beam, please see attached.
I don't yet understand G-Code and would appreciate any help rectifying the gouging that happened at the start of my code. I am using a V-bit at speed 6 on a makita. I used fusion 360 with GRBL post processing and I believe I have Grbl 0.9j (flashed on a Grbl AOI from 3dtek.xyz).
Any input is greatly appreciated.
Here's the code:
Code:
% (0005) (Extruded Rob trace v4) (T1 D=3 CR=0 - ZMIN=0 -...