Hey Guys:
Just set up a cool jig for squaring the ends of v-slot and c-beam.
A while back, I was looking at a "calibration disc" for my table saw. It's basically just a saw blade sized disc with no teeth, the idea is it gives you a nice flat surface to calibrate your fence, miter gage etc. against. Easier than using a saw blade cuz there's no teeth to get in the way.
But, the better part of all this is that they make sanding discs that fit this device, so you can turn your table saw...
A Slick way to Square up V-slot and C-Beam
Just set up a cool jig for squaring the ends of v-slot and c-beam.
A while back, I was looking at a "calibration disc" for my table saw. It's basically just a saw blade sized disc with no teeth, the idea is it gives you a nice flat surface to calibrate your fence, miter gage etc. against. Easier than using a saw blade cuz there's no teeth to get in the way.
But, the better part of all this is that they make sanding discs that fit this device, so you can turn your table saw...
A Slick way to Square up V-slot and C-Beam