I've just made my first test cuts with my OX build (OX Tale). The job is a scaled-down version of the program I plan to use to level my spoilboard.
For now it is surfacing an area of 170mm x 170mm taking a 1mm deep cut from the MDF. Cutter details and speeds are listed below.
As you can see from the photos, most of the cut area is nice and smooth, but at the right hand side I am getting hockey stick shaped marks. This is where the...
Marks when levelling spoilboard
For now it is surfacing an area of 170mm x 170mm taking a 1mm deep cut from the MDF. Cutter details and speeds are listed below.
As you can see from the photos, most of the cut area is nice and smooth, but at the right hand side I am getting hockey stick shaped marks. This is where the...
Marks when levelling spoilboard