Hi Everybody,
This will be my second CNC Router build. First being a 500mm Xcarve.
I'm about 80% percent done the mechanical build and thought I would make a few notes on how it's been going.
First small issue I ran into was the two Y pieces of C-Beam wouldn't sit down flat onto the V-Slot. Turns out the V-Slot doesn't have a bevel on the edges and the end plate bearing sits about .020 proud of the inside surface of the plate. I was puzzled as the X axis C-Beam fit fine, But the C-Beam has...
C-Beam XLarge Build
This will be my second CNC Router build. First being a 500mm Xcarve.
I'm about 80% percent done the mechanical build and thought I would make a few notes on how it's been going.
First small issue I ran into was the two Y pieces of C-Beam wouldn't sit down flat onto the V-Slot. Turns out the V-Slot doesn't have a bevel on the edges and the end plate bearing sits about .020 proud of the inside surface of the plate. I was puzzled as the X axis C-Beam fit fine, But the C-Beam has...
C-Beam XLarge Build