I have had an issue in the past where all of a sudden my X axis would suddenly start moving twice as far and twice as fast as normal, usually ruining my cut (Wood). The only fix was to replace the driver on my Arduino conk shield.
I have not had a problem recently and was working this weekend. I was going to cut some MDF which makes quite a bit of dust so I hooked up my shop vac to my dust hood and shortly after starting, my Z axis plunged down into my bed and crashed. I checked the...
How do you prevent static charge from shop vac dust hood?
I have not had a problem recently and was working this weekend. I was going to cut some MDF which makes quite a bit of dust so I hooked up my shop vac to my dust hood and shortly after starting, my Z axis plunged down into my bed and crashed. I checked the...
How do you prevent static charge from shop vac dust hood?