I have just replaced my 262oz nema23 motors with the new 245oz motors here on OB. I have started with my y axis which uses 2 motors. and I am using a 4AMp controller board. x-controller.
the 262oz seemed to be working OK. but I had a lot of cut failures on tougher materials. So I thought more power could not hurt.
I think the x-controller has enough power. but after wiring up the new motors I am getting very poor toque ot of the new motors. I can stop the gantry moving with my...
345oz motors
the 262oz seemed to be working OK. but I had a lot of cut failures on tougher materials. So I thought more power could not hurt.
I think the x-controller has enough power. but after wiring up the new motors I am getting very poor toque ot of the new motors. I can stop the gantry moving with my...
345oz motors