So i finally got around to get my ooznest ox working, but i have a slight problem in getting it dialed in...
I'm trying to cut a test circle of 49mm but it turns out slightly oval, to eliminate as much as possible i've made the circle in the mach3 wizard.
I'm using ESS and a PMDX-126 Board. my steps should be ok at 26.69485777 step for both X and Y axis.
when i measure the circle it is only 48.5mm on the Y and X axis. but when i meassure on 45 degress to x or y it is the correct...
Getting oval circles
I'm trying to cut a test circle of 49mm but it turns out slightly oval, to eliminate as much as possible i've made the circle in the mach3 wizard.
I'm using ESS and a PMDX-126 Board. my steps should be ok at 26.69485777 step for both X and Y axis.
when i measure the circle it is only 48.5mm on the Y and X axis. but when i meassure on 45 degress to x or y it is the correct...
Getting oval circles