I cut some acrylic panels for this bot made of V-slot and mounted it them using M5 low profile screws with drop-in T-nuts. The one in the front was mounted last night and looked great before I went to bed. Today I went back out and mounted the panel on top before I noticed the panel from last night had cracks at every screw. I didn't think I over tightened them and certainly didn't tighten them to the point where they left an indent. They looked just like the screws on top. Any advice on how...
Looking for Advice on Mounting Acrylic to Extrusions
Looking for Advice on Mounting Acrylic to Extrusions