Hi Everyone,
I posted this as part of a reply in the General Discussion section, however, I think this may be a better place for the question:
I'm planning to build a CNC Router that can work full 8x4 sheets of material so I'm going to need rails that are a little over 8 feet (~2500mm) long, the largest V-Slot available is 1500mm long. If I join two smaller pieces of V-Slot using some...
Larger Format Machine
I posted this as part of a reply in the General Discussion section, however, I think this may be a better place for the question:
I'm planning to build a CNC Router that can work full 8x4 sheets of material so I'm going to need rails that are a little over 8 feet (~2500mm) long, the largest V-Slot available is 1500mm long. If I join two smaller pieces of V-Slot using some...
Larger Format Machine