Hey all,
I've recently assembled a DIY CNC mill for PCB engraving.
It's working just fine but I can't seem to get it to drill. I keep receiving an error message that says "Input string was not in a correct format." I did some research and found out that grbl cant translate the drilling commands.
I find this interesting considering drilling commands are shorter and easier then the PCB routing.
I downloaded a couple of zips off github that use G83 and G81 for drilling commands but I...
Grbl Drilling
I've recently assembled a DIY CNC mill for PCB engraving.
It's working just fine but I can't seem to get it to drill. I keep receiving an error message that says "Input string was not in a correct format." I did some research and found out that grbl cant translate the drilling commands.
I find this interesting considering drilling commands are shorter and easier then the PCB routing.
I downloaded a couple of zips off github that use G83 and G81 for drilling commands but I...
Grbl Drilling