Have finally set up the ox cnc after having some problems with the first cnc xpro v2 board I bought (would not flash, so it was bricked I think)..I have ran into some problems with the second xpro v2 board and was wondering if anyone has had similar problems...
The a-axis is currently set to act as the second 'y-axis' stepper as normal on the cnc xpro v2 board, however, when I jog the y-axis (which moves fine), the mirrored a-axis eventually kicks in and starts moving a few seconds later,...
OX cnc: strange happenings with the A-axis
The a-axis is currently set to act as the second 'y-axis' stepper as normal on the cnc xpro v2 board, however, when I jog the y-axis (which moves fine), the mirrored a-axis eventually kicks in and starts moving a few seconds later,...
OX cnc: strange happenings with the A-axis