I have a C-beam machine being controlled by Grbl Panel.
when drawing a design on paper with the machine, the pen should stop, lift and move to other location. Instead, the pen keeps moving in a line in the direction between the two points. The pen should stop at the arrow in the picture below.
View attachment 22172
The gcode stopped bolded lines shown in the section of code below. This gcode was developed using ink scape and MakerCam.
Runaway Machine and Line
when drawing a design on paper with the machine, the pen should stop, lift and move to other location. Instead, the pen keeps moving in a line in the direction between the two points. The pen should stop at the arrow in the picture below.
View attachment 22172
The gcode stopped bolded lines shown in the section of code below. This gcode was developed using ink scape and MakerCam.
Code:
(Generated by PartKam Version 0.05)...